24 Channel Hi Current Relay

  • Functional test systems
  • Durability test systems
  • Manufacturing end line test systems
  • Low cost high current switching

  • Easy to use architecture
  • Affordable price
  • Extremely versatile
  • Minimum system design requirements
  • Input and Output boards can be connected
    together using a single computer card.

  • 2 sets of 24 interlaced controlled relays
  • 30 amp outputs, normally open contacts
  • 16 bits of control switching of straight thru signal or to put
    power or ground on either pin.
  • Uses (2) 16 channel relay boards to control 30 amp relays
  • Each relay board has an LED indicator board on the front
    panel and a 37 pin amp connector on the rear panel
  • 2 pair of 5-way connectors on the rear panel allowing
    external supplies to be connected separately to each of
    each 24 relays for independent supply switching
  • 7 address bit and 1 strobe bit allow for 127 boards
  • Fully compatible with all other HUB products
  • Input and output devices can be connected to same
    control bus

  • Digital input to control logic
  • Isolated input level 3 to 32 volts
  • Switch speed 1 uS
  • Input current limited to 10 mA @ 12VDC
All Interfaces  are designed with cmos technology to minimize the power consumption. In addition
there is total isolation between the computer and the device under test.

Comes in one standard size:
  • 64 channel in a 5-1/4 inch rack mount (HP014)
RMMP Test Group, LLC
A Partnership For
Your Convenience
Hi Current Interface
Hi Current Interface