16 Channel relay board
This board is both compact and versatile. All you need are four items to use this device.
1. A Keithley-Metrabyte PIO24 or Computerboards CIODIO24H board.   (plugged into your computer to control the 16 CHANNEL RELAY INTERFACE board)
2. A ribbon Cable with a DB37S connector on each end (To connect the computer to the 16 CHANNEL RELAY INTERFACE board)
3. 5V/3A power supply. (to power up the relays on the 16 CHANNEL RELAY INTERFACE board)
4. Software (To control the 16 CHANNEL RELAY INTERFACE board using your computer Quick Basic, Visual Basic, C++ etc.)
*Initialization and control software is available in Quick Basic and Visual Basic only.

Functional test systems
Durability test systems
Simulated switch inputs
Low cost high current switching
Air Actuator controls

-Easy to use architecture
-Affordable price
-Extremely versatile
-Minimum system design requirements
-Output and Input boards can be connected
together using a single computer card.

-16 individually controlled relays
-Normally open* or normally closed* contacts
-Each relay board has a 34 pin amp connector         
which can be used to drive an LED to indicate       
individual relay status
-7 address bit and 1 strobe bit allow for 127 board    
address possibilities
-Fully compatible with all other HUB Products boards.

*Specify at time of purchase

-Board Size    4-1/2"W x 6"L
-3 to 18V digital input to control logic
-External 5V relay power connection to minimize      
 computer supply draw
-Relay outputs 5 amps each
-Single SPDT relay configuration
-Isolation 10,000 volts input to output
-Each relay has seperate output pins
All boards  are designed with cmos technology to minimize the power consumption. In addition there
is total isolation between the computer and the device under test.
RMMP Test Group, LLC
A Partnership For
Your Convenience
Relay Board
Relay Board