16 Channel Scanner board
This board is both compact and versatile. All you need are four items to use this device.
1. A Keithley-Metrabyte PIO24 or Computerboards CIODIO24H board. (plugged into your computer to control the 16 CHANNEL RELAY INTERFACE board)
2. A ribbon Cable with a DB37S connector on each end (To connect the computer to the 16 CHANNEL RELAY INTERFACE board)
3. 5V/3A power supply. (to power up the relays on the 16 CHANNEL RELAY INTERFACE board)
4. Software (To control the 16 CHANNEL RELAY INTERFACE board using your computer Quick Basic, Visual Basic, C++ etc.)
*Initialization and control software is available in Quick Basic and Visual Basic only.
Functional test systems
Durability test systems
-Easy to use architecture
-Minimum system design requirements
-Output and Input boards can be connected
together using a single computer card.
-16 individually controlled relays
-Relays are multiplexed with common outputs
-Each relay board has a 34 pin amp connector
which can be used to drive an LED to indicate
individual relay status
-7 address bit and 1 strobe bit allow for 127 board
-Fully compatible with all other HUB Products boards.
*Specify at time of purchase
-Board Size 4-1/2"W x 6"L
-3 to 18V digital input to control logic
-Relay outputs 1 amps each
-Single DPDT relay configuration
-Isolation 10,000 volts input to output
-2 sets of 16 to 1 relay for milli-volt measurements etc.
All boards are designed with cmos technology to minimize the power consumption. In addition there
is total isolation between the computer and the device under test.
-A 16 channel LED board configured to plug directly
into the 16 CHANNEL SCANNER INTERFACE board is
available. (refer to part number HP003)
-A 34 pin ribbon cable to 37 pin CPC connector
board is also available. (refer part number HP004)
RMMP Test Group, LLC
A Partnership For